Shop more. Save more

Free delivery worldwide

How to Install Graphics

Before you start

Inspect your plastics, if they are scuffed and scratched or have major damage it may be worth looking at replacing them. Before applying motocross graphics kit your dirt bike plastics need to be in a reasonable / excellent condition.

For installation you will need:

– adhesive paper tape;
– paper knife / scissors;
– hair dryer or heat gun;
– degreasing agent or alcohol-water mixture;
– squeegee (optional);

Wash your hands. It is very important to have clean hands while you are preparing surface and working with graphics. Oily / dirty hands will reduce the ability of your graphics to adhere.

Preparing surface

Remove old graphics. You can use hair dryer or heat gun to warm the old graphics for easy removal. Clean the surface with degreasing agent. You do not want to leave any glue residue from the old graphics, oils or dirt. Your dirt bike plastics should be warm before applying graphics. We recommend you to keep plastics in a room with temperature more than 15°C / 60 ºF for several hours.

Applying graphics (watch video)

Place your decal over the plastic (e.g. number plate). Using adhesive paper tape, tape down the decal to the plastic. This will hold your decal in place. Use as much tape as you need.

Peel the backing paper away from the background till the middle, cut it off. Re-check your alignment on the part to be covered. Touch one side of the graphic with your finger to place it.

Working in small sections, use your thumb (or squeegee) to apply pressure to the graphic being careful not to get any wrinkles or bubbles. You have to work from the center out. If you get bubbles, carefully peel the section up and try again. Use the safety pin to pop any small air bubbles. Then smooth out the bubble section moving towards the edges of the graphic. Repeat process to the other side of the same decal.

If you have sharp curves in your plastic (e.g. number plate over exhaust pipe), use heat gun to heat the graphics so they are more pliable. Be careful not to overheat!

If needed – cut off excessive sections or sections of the graphics that are covering bolts, access holes, or vent slits – we suggest to use paper knife.

Installation tips

Take your time and be patient!

For several hours before installation, keep your dirt bike or plastics in place with temperature more than 15°C / 60 ºF for several hours.

Wait at least 24 hours before riding to make sure proper bonding is achieved.

Save & Share Cart
Your Shopping Cart will be saved and you'll be given a link. You, or anyone with the link, can use it to retrieve your Cart at any time.
Back Save & Share Cart
Your Shopping Cart will be saved with Product pictures and information, and Cart Totals. Then send it to yourself, or a friend, with a link to retrieve it at any time.
Your cart email sent successfully :)